Steel Goal Post Structure
London, Kent and Essex
Are you looking for Steel Goal Post Structure in London, Kent and Essex?
Goal Post structure is made use of for back expansions. This is where the foundations appropriate or wear pads for the columns to bear into can be dug and cast in concrete. This sort of structure enables a big aperture to be cut into the structure to support the building above. The two columns move this load to the structure and include greater lateral security.
Are you removing interior or outside bearing walls in a domestic residential property made from blocks and cinder block? It's much quicker and a lot more cost-effective than using a structural designer. It is perfect for simple structural work. There are 46 various calculation kinds. These are organised by the nature of your project.
For instance calculations for light beams that should sustain cavity wall surfaces, inner wall surfaces, floor joists, flat roofing joists and more.
General rules about steel beams:
- The ends of steel light beams need not to be located over lintels or door or home window openings
- The ends of steel beams need not encounter any existing beams or lintels
- The steel beam ought to not be placed right into a smoke-shaft and should not be within 50mm of a flue
- The steel light beam ought to be seated on a large piece of lots bearing masonry, with a plan location of the bonded stonework of at the very least 0.1 m ²
- The steel light beam should contend the very least 100mm end bearing and must be sitting on pad stones as shown on our estimations
- The supporting stonework should adhere to the requirements of Approved Document A
If you need fabricated steel beams for any size project then get in contact to discuss your requirements.
Contact usCall 020 8311 8642